Are You Getting the Most Out of Your Montclair painters?

Feather Out Paint Where You Can't Keep a Wet Edge

You can't cover huge areas like ceilings, extra-tall walls or stairwells in solitary, continual strokes, so the best method to reduce lap marks on these locations is to feather out the paint along the edges that you can't keep wet. The thinner, feathery layer of paint will certainly avoid the accumulation that triggers the lap mark.

To Additional reading paint a big area without leaving lap marks, roll the almost completely dry roller in different directions along the completely dry edge, feathering out the paint as you go. After finishing the entire size of the wall surface or ceiling, move to the next area and also paint over the feathered edges.

For the 2nd coat, apply the paint in the opposite instructions. This crisscrossing paint application sharply reduces (if not removes) lap marks.

10/ 10

indoor painting ideas sand trimFamily Handyman

Sand Trim Between Coats for an Ultra-Smooth End up

One layer of paint usually will not hide the underlying shade and shine on trim. And also if you do not sand the surface smooth in between coats, the finish may have a rough structure. For a smooth coating, sand the trim prior to applying each layer of paint.

Sand the trim with a fine-grit fining sand sponge. Sponges enter into crevices where sandpaper can't go and allow you use also pressure.

Then apply the first coat of paint, let it dry at least 24 hr, lightly sand it once again for a completely smooth surface area, and also apply the second coat. After each sanding, vacuum the trim, then clean it down with a tack towel to eliminate the dust.